Synchronous Wireless Remote Control Two 12V or 24V Electric Linear Actuators


Use 1 channel DC 30A long range wireless remote control linear actuator switch kit with RF transmitter and receiver to synchronously control two 12V or 24V electric linear actuators, these two linear actuators are the same working voltage, telescopic speed and stroke.

Used with linear actuators for long distance wireless control the pergola, car, truck, trunk, lifting platform, massage chair, massage seat, solar tracker, sofa, etc.

Operating:
Press button ▲ on the remote: The two electric linear actuators extend outward
Press button ■ on the remote: The two electric linear actuators stop extending outward

Press button ▼ on the remote: The two electric linear actuators retract inward
Press button ■ on the remote: The two electric linear actuators stop retracting inward

Comments

Post a Comment

Popular posts from this blog

What is Toggle / Momentary / Latched Modes

Generally there are three working modes for rf remote controls : toggle, momentary, latched. Toggle mode is used most often. Controlling lamp, for example, press the button of remote, turn on the lamp; press the button again, turn off the lamp. Momentary mode can be set to control rolling blind or rolling door. You need to press and hold the button of remote to make the blind or door open/close. Both toggle and momentary mode are motivated by single relay, which means you can work these two modes with single button remote. As regards the latched mode, it is motivated by relay group. For relay group, only one relay will be on at a time, e.g. press remote button A, relay A will be on, and relay B will be off; press remote button B, relay B will be on, and relay A will be off. To be more specific, when you control the lamp by latched mode, you should prepare at least two buttons remote. Press button A, the lamp is on; press button B, the lamp is off. Information from: http://
Read more

Difference between traditional two-way switch and new electrical touch two-way switch

Image
Various electrical touch two-way light switch from  https://www.remote-control-switch.com Generally speaking, two-way switch controls one light from two locations: for example, the long hallway could have a switch at each end to control one hall light. Or a large family room that has two entrances could have a switch at both entrances to operate one overhead light. A two-way switch allows you to turn on the light conveniently when you enter an area rather than stumble through the dark to find the switch. Now we are going to talk about the difference between traditional two-way light switch and new electrical touch two-way switch. First of all, let’s see what are traditional two-way switch and new touch two-way switch. Traditional two-way switch has a single pole double throw configuration (SPDT). Each has a common terminal (COM) with a pole that can be switched between position L1 or L2. As diagram below shows, the live wire is connected to Switch1, and flow to the lamp through L1
Read more