Utilitarian 30A 2000M AC Remote Control Unit for Irrigation


Question from customer:

I need to start and stop an electric motor (water pump) 1500 meters away from a house. The water pump is initiated by an irrigation controller. A relay n/o or n/c contact is automatically operated from the irrigation controller when no one is home. Currently there are 2 wires running all the way and are regularly damaged by cows, fires, machinery. I wish to start and stop this motor via remote control, but there are no always people there to push the button on a remote control. This start is initiated by a voltage free relay contact.

Answer:

We recommend the 1 channel high power long range receiver S1PU-AC220-ANT2 and 5~28V triggered transmitter CB-2V.



The outstanding feature of this transmitter is that it has two wires, when two wires connect to low voltage, transmitter will send signal to receiver to activate controlled appliance.
 
The receiver is 1 channel with extended antenna and multiple working modes. When it pairs with its transmitter, its transmitting distance is up to 2000M in the open air.  

Here is the wiring diagram for transmitter and receiver.

For transmitter, you can manage to find an electric device as a triggered switch for its two wires. Do as following shown, connect two wires to electric device.



For the receiver, there are normally open/ closed terminals. Usually, we wire electric device to the normally open terminals. So A&B terminals are normally open; A&C terminals are normally closed. We can connect motor to A&B terminals. And connect a wire between B&L terminals and another wire to A&N terminals. Through N&L terminals, supply AC power to the receiver.



When the transmitter is triggered by low voltage to two wires, it will transmit “ON” signal to receiver to open the irrigation pump. When power is cut off, it will transmit “OFF” signal to receiver to stop the irrigation pump.

Comments

Post a Comment

Popular posts from this blog

Two way switch, or three way switch?

Image
Switches are classified according to the arrangement of their contacts in electronics. Electricians installing building wiring use different nomenclature, such as "one-way", "two-way", "three-way" and "four-way" switches, which have different meanings in North American and British cultural regions. If we say one-way switch in British cultural regions, it will be described as two-way switch in North American regions; and two-way switch will be described as three way switch and so forth. As a result, sometimes people will make misunderstanding about them. For example, people from USA say two-way light switch actually is called one-way light switch in UK. And if they don’t know the reason, they will get into a fight. Table below is to distinguish the difference between them. (Pole means separate circuit which are controlled by a switch. Throws means separate position that the switch can adopt.) Excellent two (three) way light switch from...
Read more

2 Channel DC Remote Controller Controls AC Motor to Rotate Forward and Reverse

This 2CH RF DC remote control kit is activated by DC power supply, which operates in toggle, momentary, latched and toggle +momentary modes (just set according to your requirement).It is very favorable for lights or other DC/AC electric devices which are hard to reach or far away from switch. This 2 channel remote control kit can help you complete two operations at the same time. It is widely used for lights, gates, garage doors, motors and so on. We will try to show you how to control positive and reversal rotation of an AC motor with this remote module.
Read more