30amps Remote Controller for 1/2 HP Motor

Question from Customer:
“I am looking for a remote controller to start and stop a motor of 1/2 horsepower from a distance of 250 – 300 feet. The motor is 115 volts AC. Which unit is correct for this application?”
HP motor
Answer:
We recommend 1 channel AC 30amps 2000m Remote Controller (S1PX-AC220-ANT2 & CB-2) to you.
long range remote control kit-our automation
There are 3 working modes in this kit. They are toggle, momentary and lathed mode. You can choose momentary or latched mode.
Momentary Mode: Only connect Jumper-1.
Press and hold big button: Turn on the relay, terminal OUT outputs AC power, motor starts.
Release big button: Turn off the relay, terminal OUT no output, motor stops.
Latched Mode: Do not connect Jumper-1 and Jumper-2.
Press big button: Turn on the relay, terminal OUT outputs AC power, motor starts .
Press small button: Turn off the relay, terminal OUT no output, motor stops.
The controller’s transmitting distance can be about 2000m in the open field. With its high amp load-30amp, it is enough strong to actuate your motor. In addition, this kit has ac power output contact, you can do as the follow-up wiring diagram shown.
Wire motor to ‘OUTPUT” terminal of receiver. And supply power to receiver. Then you can remote control the motor.
motor-wiring-diagram-our-automation

Comments

Post a Comment

Popular posts from this blog

Two way switch, or three way switch?

Image
Switches are classified according to the arrangement of their contacts in electronics. Electricians installing building wiring use different nomenclature, such as "one-way", "two-way", "three-way" and "four-way" switches, which have different meanings in North American and British cultural regions. If we say one-way switch in British cultural regions, it will be described as two-way switch in North American regions; and two-way switch will be described as three way switch and so forth. As a result, sometimes people will make misunderstanding about them. For example, people from USA say two-way light switch actually is called one-way light switch in UK. And if they don’t know the reason, they will get into a fight. Table below is to distinguish the difference between them. (Pole means separate circuit which are controlled by a switch. Throws means separate position that the switch can adopt.) Excellent two (three) way light switch from...
Read more

2 Channel DC Remote Controller Controls AC Motor to Rotate Forward and Reverse

This 2CH RF DC remote control kit is activated by DC power supply, which operates in toggle, momentary, latched and toggle +momentary modes (just set according to your requirement).It is very favorable for lights or other DC/AC electric devices which are hard to reach or far away from switch. This 2 channel remote control kit can help you complete two operations at the same time. It is widely used for lights, gates, garage doors, motors and so on. We will try to show you how to control positive and reversal rotation of an AC motor with this remote module.
Read more