How to Install a Single Pole Wall Light Switch?

Following installation is suitable for all kinds of single pole wall light switches, such as touch light switch, remote touch light switch, two way touch light switch, touch timer switch, etc. 

Firstly, shut off the power to the circuit and remove the switch cover with screwdriver.



Secondly, Connect the wires to the switch’s screw terminals, do as below:




Thirdly, Fix the switch to internal box with two screws.



Finally, fix the cover.


Comments

Post a Comment

Popular posts from this blog

How to Use an External Limit Switch with a Linear Actuator

Image
An  external limit switch  is a very handy and cost effective means of controlling the travel of a  linear actuator . Here we will go over how to use an external limit switch with a linear actuator. Most electric linear actuators are made with built-in limit switches. This means you are able to adjust the travel of the stroke to your precise desired position. Not all linear actuators are built limit switches. So what do you do when the linear actuators stroke is longer than you need? Installing an external limit switch is the simplest and most affordable method to control the travel in electric linear actuators where the limit switch is either non-adjustable or non-existent. There are three ways to control the stroke: Limit extension Limit retraction Limit both extension and retraction What is a Built-In Linear Actuator Limit Switch? All our linear actuators have internal limit switches at the fully extended and retracted positions. These limit switches ensure that when ...
Read more

How Do You Control DC 12V 24V Electric Linear Actuator by Manual Switch?

Image
What Type of Manual Switch Do You Need? We have a lots of types of manual electrical switches, so how do you know which one is best for controlling a  12V or 24V linear actuator . As you are most likely wanting to extend and retract your linear actuator, you’ll want to use a 3 position toggle switch (Double Pole Double Throw (DPDT) ON-OFF-ON switch), or manual controller with wire handle. 3 Position ON-OFF-ON Toggle Switch 3 position toggle switch will allow you to change the direction of the input voltage to the actuator, which is needed to change directions, while a double throw gives you two ON positions, and OFF position; one ON position for extension, the other ON position for retraction, and OFF position for stop. Maximum load current is 15A.     Manual Controller with Wire Handle 1)  24V Manual Controller with Wire Handle for 2000N Linear Actuator The manual controller input voltage is AC100 ~ 240V, DC 24V output and maximum output current is 3A;The contr...
Read more

Manually Control Electric Linear Actuator through DC 12V 24V Wired Handle

Image
Manually control extending and retracting of the electric linear actuator through a wired handle with DC 12V 24V power adapter . Product parameters: Input voltage: AC100~240V Output voltage: DC12V or 24V optional Maximum output current: 6A/DC12V or 5A/DC24V optional Wired control handle with two buttons, momentary work mode. Suitable for DC 12V or 24V 500N or 2000N series of linear actuators. Wiring: Connect the wired control handle to the power adapter and linear actuator, and then connect the plug of the power adapter to AC power supply. Operating: Press and hold the button "Extended" on the handle: The linear actuator will extend outward; Release the button: The linear actuator stops extending outward. Press and hold the button "retracted" on the handle: The linear actuator retracts inward; Release the button: The linear actuator stops retracting inward.
Read more